SCANNERFRAME & SMARTBACK INSTALLATION
Scanner Frame and Link 2500i Smartback Installation
Once assembly is complete, please reach out to Store Support to finalize configuration.
Requirements: Please ensure all pieces are available before proceeding, and Power Off the Tablet.
· An existing PAR tablet
· ScannerFrame case
· 2500i Series Smartback
· Link 2500i series CC reader
· Small Phillips head screwdriver
· Small Flathead screwdriver
1. Using the Torx screwdriver included with the ScannerFrame, begin by removing the screws from the front side of the existing tablet case. The screws are located on the front side of the case around the edges.
2. Once all screws are removed, carefully separate the two pieces of the cover, and set the tablet aside.
3. Next, follow the Mounting Instructions in the ScannerFrame guide starting on Page 4 to install onto the tablet. A few guiding photos are below.
3a: Bottom and Side Hatches removed
3b: Cover Plate Removal and Grounding Spring installation
3c: USB connector on tablet case must align and be fully seated into the USB port on the right side of the tablet. The cable has some play in it, and can be lifted slightly to help align when connecting.
4. With the frame fully installed, flip the tablet over and lay on its face. Remove the back panel from the tablet by lifting up from the bottom left corner.
5. Next align the Smartback plate so as the connecting pins for the reader are oriented at the bottom, and the notch on the plate is on the lower left. Press down firmly to connect, then use the 4 included screws to attach.
6. Insert the Link 2500i CC reader into the Smartback, by inserting at the top of the bracket and sliding downward. Use the included set screw to lock into place on the left side of the reader, shown below.
7. Once complete, reach out to Zaxby’s Store Support for final configuration steps.